Stihl MSA 160 C-BQ Product Instruction Manual - Page 18
To Avoid Pull-in, B = Pushback, To Avoid Pushback, Cutting Techniques, Felling, Warning
View all Stihl MSA 160 C-BQ manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 18 highlights
English a foreign object in the wood. The reaction of the chain pulls the saw forward and may cause the operator to lose control. Pull-in frequently occurs when the bumper spike of the saw is not held securely against the tree or limb and when the chain is not rotating at full speed before it contacts the wood. Warning! Use extreme caution when cutting small size brush and saplings which may easily catch the chain, be whipped toward you or pull you off balance. To Avoid Pull-in 1. Always start a cut with the chain rotating at full speed and the bumper spike in contact with the wood. 2. The risk of pull-in may also be reduced by using wedges to open the kerf or cut. B = Pushback B Pushback occurs when the chain on the top of the bar is suddenly stopped when it is pinched, caught or encounters a foreign object in the wood. The reaction of the chain may drive the saw rapidly straight back toward the operator and 001BA038 KN may cause loss of saw control. Pushback frequently occurs when the top of the bar is used for cutting. To Avoid Pushback 1. Be alert to forces or situations that may cause material to pinch the top of the chain. 2. Do not cut more than one log at a time. 3. Do not twist the saw when withdrawing the bar from a plunge cut or underbuck cut because the chain can pinch. Cutting Techniques These general instructions apply to all chain saws. As stated above, however, STIHL recommends against the use of your cordless electric chain saw for cutting trees, logs or branches having a diameter of more than 8 inches. Warning! For cutting larger trees, logs or branches, a more powerful, faster and/or steady cut may be necessary to reduce the risk of binding, stalling or a change in conditions during a longer cutting time that could lead to a loss of control of the object being cut and serious personal injury. Felling Felling is cutting down a tree. The cordless chain saw is of only limited suitability for felling and limbing. If, however, a tree is to be felled and limbed with a cordless chain saw, it is imperative to observe the following instructions. Before felling a tree, consider carefully all conditions which may affect the direction of fall. Warning! There are a number of factors that may affect and change the intended direction of fall, e.g. wind direction and speed, lean of tree, surrounding trees and obstacles, sloping ground, one-sided limb structure, wood structure, decay, snow load, etc. To reduce the risk of severe or fatal injury to yourself or others, look for these conditions prior to beginning the cut, and be alert for a change in direction while the tree is falling. Warning! Always observe the general condition of the tree. Inexperienced users should never attempt to cut trees that are decayed or rotted inside or that are leaning or otherwise under tension. There is an increased risk that such trees could snap or split while being cut and cause serious or fatal injury to the operator or bystanders. Also look for broken or dead branches which could vibrate loose and fall on the operator. When felling on a slope, the operator should stand on the uphill side if possible. 16 MSA 160 C