Stihl MSA 160 C-BQ Product Instruction Manual - Page 32
Light Emitting Diodes, LED on Battery
View all Stihl MSA 160 C-BQ manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 32 highlights
English 34 The light emitting diode (3) on the charger comes on when the battery is inserted - see "Light Emitting Diodes (LED) on Charger" Charging begins as soon as the light emitting diodes (4) on the battery light up green - see "Light Emitting Diodes (LED) on Battery". The charge time is dependent on a number of factors, including battery condition, ambient temperature, etc., and may therefore vary from the charge time in the "Specifications". The battery becomes hot during operation. If a hot battery is inserted in the charger, it may be necessary to cool it down before charging. The charging process begins only after the battery has cooled down. The time required for cooling may prolong the charge time. The battery and charger become warm during the charging process. AL 300 charger 3901BA014 KN 3901BA010 KN AL 100 charger This charger waits for the battery to cool down before starting the charging process. The battery is cooled normally by heat transfer to the ambient air. End of charge The charger switches itself off automatically when the battery is fully charged: - Light emitting diodes on the battery go off - The light emitting diode on the charger goes off - The charger's fan is switched off (if charger is so equipped) Remove the charged battery from the charger. Light Emitting Diodes (LED) on Battery Four LEDs indicate the charge state of the battery as well as any problems that occur with the battery or the machine. 1 N Press button (1) to activate the display - display switches off automatically after 5 seconds The LEDs can be green, red or flashing. LED is continuously green. LED flashes green. LED is continuously red. LED flashes red. This charger is equipped with a battery cooling fan which is audible when it is running. 30 MSA 160 C