Stihl TS 700 Instruction Manual - Page 26
Illustration B.
View all Stihl TS 700 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 26 highlights
English wheel. This can lead to kickback, other reactive forces or a shattered composite cutting wheel, which could result in severe or fatal personal injury. N If necessary, leave small sections that hold the part that is to be separated in position. Break these sections manually with a hammer or other appropriate tool after making the last cut. If the outer diameter of the pipe or other round, hollow body is smaller than the maximum cutting depth of the wheel: top portion of the pipe using the bottom section of the cutting wheel with the guard covering the top of the wheel. If the pipe is in-ground or otherwise cannot be rolled: N Support the pipe and chock it if necessary to prevent it from rolling, moving or vibrating. N Rotate the guard to the rear limit stop. A C 0000-GXX-5757-A0 N Next, make a cut from the top half of the pipe down, connecting with the cut from the lower half. Illustration C. Do not attempt to twist or bend the machine or wheel to join the two cuts. D X 0000-GXX-5755-A0 0000-GXX-5758-A0 002BA558 AM N Make one cut from the top to the bottom of the pipe. If the outer diameter of the pipe or other round, hollow body is greater than the maximum cutting depth of the wheel: Plan first, then cut. The sequence shown in this manual is illustrative and not meant to substitute for the judgment of the experienced workmen with actual knowledge of on-site conditions. However, the last cut must always be made in such a way that the cutting wheel cannot become pinched, bound or clamped and so that the operator, coworkers and bystanders are not at risk of being injured by a falling part that has been cut off or out, by cutting debris or sparks. Generally, this should be in the N To reduce the risk of pinching or binding and kickback, start cutting in the lower section of the pipe. Illustration A. B N Use the front and upper part of the abrasive wheel for cutting the opposite lower side. Make sure that the cut at the bottom is complete. Illustration B. 0000-GXX-5756-A0 N Make a cut in the marked area shown above, leaving uncut the section labeled "X" in the illustration. Connect the cut with the cut in the lower half. Do not attempt to twist or bend the machine or wheel to join the two cuts. To keep the pipe from pinching, binding or clamping, do not cut into the area labeled "X." Illustration D. Only make the final top cut once all bottom and lateral cuts have been completed and connect with one another. 24 TS 700, TS 800