Stihl TS 700 Instruction Manual - Page 35
Slacken the V-belt
View all Stihl TS 700 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 35 highlights
Connecting the water connection 3 1 2 1 N Insert the longer banjo bolt (1) through the connector (2) of the water attachment - observe the position of the connector N Insert the square nut into the guide in the guard and hold it in place N Fit the support with the longer banjo bolt on the adjusting lever (3) - screw in the banjo bolt and tighten with the combination wrench 376BA087 KN Checking the adjustment range of the guard A N Rotate the guard forwards and backwards as far as possible - adjustment range (A) must be limited by the stop pin Continue as described in the chapter "Tensioning the V-belt". Inboard mounting (TS 700) N Disassemble the abrasive wheel (see "Fitting / replacing an abrasive wheel") N Remove the water attachment N Remove the adjusting lever N Slacken the V-belt N Remove the V-belt guard N Remove "support with guard" 376BA088 KN English Preparing the "support with guard" for inboard mounting 1 2 3 N Unscrew the screw (1) of the limit stop (2) N Remove the limit stop (2) N Unscrew the stop pin (3) 2 1 3 N Turn the guard so that it is in the position shown (see picture) N Screw in and tighten the stop pin (3) N Insert limit stop (2) - align the hole in the limit stop with the hole in the bearing N Insert and tighten the screw (1) N Install the adjusting lever N Mount "support with guard" - guard on the inboard side N Install the V-belt guard N Connect the water connection 376BA083 KN 376BA089 KN TS 700, TS 800 33