Sub-Zero BI-36S Sub-Zero Design Guide - Page 11

Built-In Refrigeration 11 subzero.com/specs Planning Information ELECTRICAL REQUIREMENTS For all built-in models, the electrical supply should be located within the shaded area shown in the illustration. Follow the National Electrical Code and local codes and ordinances when installing the receptacle. A separate circuit servicing only this appliance is required. A ground fault circuit interrupter (GFCI) is not recommended and may cause interruption of operation. Electrical Requirements Power Supply Circuit Breaker Receptacle 115 V AC, 60 Hz 15 amp 3-prong grounding-type FRONT VIEW 7" (178) E 6" (152) 751/2" (1918) FROM FLOOR Location of electrical supply. PLUMBING REQUIREMENTS All built-in models with an automatic ice maker feature a water filtration system. The water supply line should be located within the shaded area shown in the illustrations. The water supply line should be connected to the house supply with an easily accessible shut-off valve between the supply and the unit. Do not use self-piercing valves. A saddle valve kit is available through your authorized Sub-Zero dealer. The water line must not interfere with installation of the anti-tip brackets. IMPORTANT NOTE: A reverse osmosis system can be used provided there is constant water pressure of 35 psi (2.4 bar) to 120 psi (8.3 bar) supplied to the unit at all times. In this application, the water filtration system must be set to bypass mode. This is achieved by removing the water filter cartridge. Refer to the built-in installation guide packed with the unit for detailed instructions. A copper line is not recommended for this application. Plumbing Requirements Water Supply Line 1/4" OD copper, braided stainless steel or PEX tubing Water Pressure 35-120 psi (2.4-8.3 bar) Excess Water Line for Connection 36" (914) 18" (457) FLOOR 6" (152) 3" (76) FRONT VIEW 1/2" BACK WALL (13) 18" (457) 6" (152) TOP VIEW Location of water supply- rear. Location of water supply- bottom.