Sub-Zero BI-36S Built-In Use & Care Guide - Page 16

Built-In Use & Care 16 Refrigerator Storage STORAGE DRAWERS To remove a storage drawer in the refrigerator section, pull the drawer out until it stops. Lift the font of the drawer slightly and pull the drawer straight forward. Refer to the illustration below. IMPORTANT NOTE: If the door opening is limited to 0°, the shallow door shelves will need to be removed from the bottom of the door in order to remove a drawer. To reinstall, push the drawer slides back into the refrigerator. Align the drawer with the slides, then push the drawer straight back on to the slides until it stops. Press downward on the front of the drawer to engage the slides. DOOR SHELVES AND DAIRY COMPARTMENT The door shelves and dairy compartment are adjustable within the guides of the door liner. Glass door models do not have door shelves or a dairy compartment. To remove a shelf or the dairy compartment, lift it up and out from the bottom. To reinstall, push it down into the guides. Refer to the illustration below. ADJUSTABLE GLASS SHELVES IMPORTANT NOTE: Be sure to read the following instructions before removing or adjusting glass shelves. Use care when handling glass shelves to prevent breaking the glass or scratching the interior. To remove or adjust a glass shelf, first tilt the shelf up at the front, then lift it up and out of the tracks on the rear wall of the refrigerator. Refer to the illustration below. If the door opening is limited to 0°, you may need to take out door shelves in order to remove the glass shelf. Lift and pivot the end of the glass shelf nearest the door upward, and remove. To replace a glass shelf, insert it in the tracks at the rear of the refrigerator with the front of the shelf raised slightly. As you push the shelf in, lower the front of the shelf until it locks into position. Glass shelves should warm to room temperature before immersing in warm water. Storage drawer removal. Door shelf removal. Glass shelf removal.