Sub-Zero BI-36S Built-In Use & Care Guide - Page 17

Built-In Use & Care 17 subzero.com Freezer Storage FREEZER BASKET REMOVAL IMPORTANT NOTE: Unload freezer baskets before removal. Model BI-36F and side-by-side models: To remove the freezer basket, pull it out until it stops. Behind the bottom two corners of the front face of the basket are metal clips. Pull these clips toward the front of the basket, lift and rotate the basket up. Refer to the illustration below. To reinstall, push the drawer slides back into the freezer. Align the basket with the slides and push the basket back onto the slides until it stops. Press down on the front of the basket to engage the basket clips with the slides. IMPORTANT NOTE: To remove freezer baskets from models BI-36S, BI-42S, BI-42SID or BI-42SD, the basket must be raised and pulled through the opening in the door liner after disengaging the basket from the slides. IMPORTANT NOTE: If models BI-36F or BI-36S are limited to a 0° opening, it may be necessary to remove the basket and shelf above in order to remove the basket. Over-and-under models: To remove the upper freezer basket, lift up on the front and pull forward to release the basket. To remove the lower freezer basket, lift the basket directly upward and out. Refer to the illustration below. To reinstall the lower freezer basket, insert the basket into the four corner retainers. To reinstall the upper freezer basket, position the basket onto the slide rails. Slide the basket towards the back until you hear a click. ICE CONTAINER REMOVAL Model BI-36F and over-and-under models: To remove the ice container, pull the freezer basket or the freezer drawer out until it stops and lift the ice container out. Models BI-36S, BI-42S and BI-48S: To remove the ice container, pull the container forward until it stops and lift the container to clear the carrier assembly along the back edge of the container. Once the container has cleared the assembly, pull forward and out. If the door opening is limited to 0°, use the same procedure, but when lifting the ice container out, pivot the right side of the container toward you and out. This will allow the ice container to clear the door. Refer to the illustration below. Models BI-42SID, BI-42SD, BI-48SID and BI-48SD: To remove the ice container, pull the container out partially, then rotate the right side of the container as you continue to pull the container out. Refer to the illustration below. Ice container (BI-36S, BI-42S Ice container (BI-42SID, and BI-48S). BI-42SD, BI-48SID, BI-48SD). Freezer basket (BI-36F and side-by-side models). Freezer basket (over-andunder models).