Sub-Zero BI-36S Built-In Use & Care Guide - Page 29
Built-In Use & Care, Cleaning
View all Sub-Zero BI-36S manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 29 highlights
Built-In Use & Care 2 subzero.com Cleaning STAINLESS STEEL EXTERIOR To clean the exterior of a stainless steel model, use a soft, nonabrasive stainless steel cleaner like Signature polish and apply with a soft lint-free cloth. Signature polish is available from Signature Limited Laboratory, P. O. Box 13436, Dayton, Ohio 45413, or call 877-376-5474. To bring out the natural luster of the stainless steel, lightly wipe the surface with a water-dampened microfiber cloth followed by a dry polishing chamois. All work should follow the grain direction of the finish. Better results are obtained by keeping the cloth in continuous contact with the stainless steel. Do not use a metallic or highly abrasive cleaner or cloth, as this will scratch the stainless steel finish. CONDENSER CLEANING For all built-in models, the condenser is located behind the flip-up grille. To access, pull out on the bottom edge of the grill and tilt forward. Using a soft bristle brush, vacuum to remove dust and lint from the condenser area. Refer to the illustration below for location of the condenser. IMPORTANT NOTE: To avoid bending the condenser fins, be sure to vacuum in the direction of the fins (up and down). Clean the condenser area every three to six months. Before cleaning the condenser, shut off power to the unit at the control panel. Wear gloves to avoid injury from sharp condenser fins. Failure to clean the condenser could result in temperature loss or mechanical failure or damage. CONDENSER Location of condenser.