Sub-Zero BI-42UFD Built-In Design Guide - Page 19

BUILT-IN REFRIGERATION Custom Panels FLUSH INSET PANELS The flush inset application is an overlay model with flush inset panels. It is not a separate model. The flush inset design allows custom panels to be installed flush with adjacent cabinets. Similar to overlay, flush inset panels are typically created by combining a 3/4" (19) custom panel, a .10" (3) spacer panel and a 1/4" (6) backer panel. Refer to the illustrations for overlay panels. For flush inset panels thicker than 3/4" (19), a 90° door stop may be required to prevent interference with adjacent cabinets. Refer to the full-scale templates at the end of this guide. When installing two units side by side, refer to page 15 for dual flush inset installations. ICE AND WATER DISPENSER For models BI-42SD and BI‑48SD, the refrigerator door panel must include a cut-out to accommodate the external dispenser. The thickness of the panel in this area can range from 1/4" (6) to a maximum of 11/8" (29). Refer to the illustrations below. 5/8" 3/32" (16) (2) 6 5/16" (160) 12 7/8" (327) 1/8" (3) RADIUS 2" (51) HANDLE GLASSWELL 1" (25) Dispenser dimensions. Handle placement. subzero.com/specs | 19