Symphonic ST191B Owner's Manual - Page 13

TO ERASE A MEMORIZED CHANNEL 1 Select the channel that you wish to erase by pressing the CHANNEL UP (or DOWN) button until the desired channel number appears on the screen. Or you may use number buttons of the remote control unit. (Selected channel number displays in light blue. 32 V CHANNEL A SETTING THE SLEEP TIMER The sleep timer function enables you to shut off the power without pressing POWER button after a desired period. 1 Press SLEEP button of remote control unit. The shut off time can be determined by the number of times you press the button. (Ex. 2 presses for 90 minutes) • Make sure that you are in the SKIP mode using your SKIP/SEARCH button on the remote control. 2 Press ADD/CLEAR button. (The displayed channel number will change to light red 32 ADO, Note: SKIP: Tuner stops at next programed channel. SEARCH: Tuner stops at next channel available in your area whether it is programed or not. • Programed channel displayed in light blue. • Unmemorized channel displayed in light red. 3 Press CHANNEL UP (or DOWN) button and that channel is now erased from memory. SLEEP SLEEP 90 1 press 2 presses 3 presses 4 presses 5 presses 6 presses 7 presses 8 presses 9 presses 10 presses 11 presses SLEEPTIME 0 minute 90 minutes 80 minutes 70 minutes 60 minutes 50 minutes 40 minutes 30 minutes 20 minutes 10 minutes 0 minute DISPLAY Sleep 0 Sleep 90 Sleep 80 Sleep 70 Sleep 60 Sleep 50 Sleep 40 Sleep 30 Sleep 20 Sleep 10 Sleep 0 The timer display counts down and sleep timer will be displayed on the screen when you press the SLEEP button on remote control unit.) V CHANNEL A Repeat steps [1] to [3] for every channel you wish to erase. NOTE: When you disconnect the unit, or if you have a power failure, all the memory, such as channel program, sleep time, will be lost. You have to repeat each preset procedures. - 13 - EN