Symphonic WF802 Owner's Manual - Page 14
Connecting To A Tv That Has An, S-video Input Jack Or Component Video In Jacks, Connecting To A Tv,
View all Symphonic WF802 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
HOOKUPS DVD/VCR TO TV CONNECTION SETTING THE CH3/CH4 SWITCH 1. Disconnect the AC power cord of the TV from the AC outlet. 2. Disconnect the antenna or cable from the TV. 3. Connect the antenna or cable to the ANT-IN jack of the DVD/VCR. 4. Connect the DVD/VCR to the TV using the coaxial cable. 5. Plug the AC power cords of the DVD/VCR and TV into the AC outlets. [VHF/UHF [Indoor antenna] combination antenna] [Back of the DVD/VCR] [Back of the UHF/VHF combination TV] OR [Cable box or satellite box] OR From Cable or Satellite Company IN OUT Coaxial cable ANT - IN (supplied) ANT - OUT CH3 CH4 UHF/VHF If your TV does not have A/V terminals: When the DVD/VCR is in the VCR Playback mode or when the DVD/VCR is in the VCR mode, your TV will receive signals from the DVD/VCR on either channel 3 or channel 4. To use the DVD/VCR with your TV, set the selector switch to CH3 or CH4 (which is located in the back of your DVD/VCR), whichever is not used for normal broadcasts in your area. Then set your TV to the same channel. CH3 CH4 ANT - IN ANT - OUT CH3 CH4 [Back of the DVD/VCR] Note to CATV system installer This reminder is provided to call the CATV system installer's attention to Article 820-40 of the NEC that provides guidelines for proper grounding and, in particular, specifies that the cable ground should be connected to the grounding system of the building, as close to the point of cable entry as practical. CONNECTING TO A TV Antenna/Cable signal ANT-IN A/V-compatible or wide screen TV To ANT. IN of TV ANT - OUT CH3 CH4 To VIDEO INPUT jack IN L AUDO R DVD/VCR OUT DVD/VCR AUDIO OUT L VIDEO R S-VIDEO DIGITAL AUDIO OUT OUT PCM / BITSTREAM COAXIAL To VIDEO OUT jack [Fig. 1] To Right (red) and Left (white) Notes AUDIO INPUT jacks AUDIO OUT jacks ¡Connect the DVD/VCR directly to a TV. If the A/V cables are connected to a VCR, pictures may be distorted due to the copy protection system. CONNECTING TO A TV THAT HAS AN S-VIDEO INPUT JACK OR COMPONENT VIDEO IN JACKS FOR TVs WITH S-VIDEO INPUT JACK Use an S-Video cable (commercially available) in place of the yellow video cable to enjoy higher quality pictures. The S-Video connection only supplies video (picture) in the DVD mode of the DVD/VCR. Therefore, in order to use the VCR features or view TV channels on the DVD/VCR, you still need to either connect the RF coaxial cable between the ANT-OUT jack of the DVD/VCR and the TV's Antenna In jack, or connect the yellow video cable as described earlier (Fig.1). To connect the supplied RF coaxial cable, see "DVD/VCR TO TV CONNECTION" above. A/V-compatible or wide screen TV ANT - IN ANT - OUT CH3 CH4 IN L AUDO R DVD/VCR OUT DVD/VCR AUDIO OUT L VIDEO R S-VIDEO DIGITAL AUDIO OUT OUT PCM / BITSTREAM COAXIAL To Right (red) and Left (white) AUDIO INPUT jacks AUDIO OUT jacks To S-VIDEO INPUT jack To S-VIDEO OUT jack - 14 - [Fig. 2] EN 1L25