Synology DS220j Hardware Installation Guide - Page 8

Hardware Setup, Tools and Parts for Component Installation, Install Drives

Page 8 highlights

Chapter Hardware Setup 2 Tools and Parts for Component Installation Please prepare the tools and parts below before setting up your Synology NAS: • A Screwdriver • At least one 3.5" or 2.5" SATA drive (please visit www.synology.com/compatibility for compatible drive models) Warning: If you install a drive that contains data, the system will format the drive and erase all existing data. Please back up any important data before installation. Install Drives 1 Push the upper case in the direction as shown below. Lift the upper case and set it aside. 2 Install drives: • For 3.5" drives with 3 screw holes on each side (indicated below): a Slide the drive into the hard drive bay, and push it all the way until it's firmly connected to the SATA connector. b Secure the drive with the screws provided. • For 3.5" drives with 2 screw holes on each side (indicated below): a Place the HDD bracket on your Synology NAS, and fasten the bracket to the Synology NAS with the screws provided. 8

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20

Tools and Parts for Component Installation
Please prepare the tools and parts below before setting up your Synology NAS:
• A Screwdriver
At least one 3.5” or 2.5” SATA drive (please visit
www.synology.com/compatibility
for compatible drive
models)
Warning:
If you install a drive that contains data, the system will format the drive and erase all existing data. Please
back up any important data before installation.
Install Drives
1
Push the upper case in the direction as shown below. Lift the upper case and set it aside.
2
Install drives:
For 3.5” drives with 3 screw holes on each side (indicated below):
a
Slide the drive into the hard drive bay, and push it all the way until it’s firmly connected to the SATA
connector.
b
Secure the drive with the screws provided.
For 3.5” drives with 2 screw holes on each side (indicated below):
a
Place the HDD bracket on your Synology NAS, and fasten the bracket to the Synology NAS with the
screws provided.
Hardware Setup
8
2
Chapter