TASCAM CD-RW901 Owners Manual - Page 27
Fade-in and fade-out recording, Synchronized recording, Sync recording
View all TASCAM CD-RW901 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 27 highlights
5 − Recording Advanced recording Fade-in and fade-out recording At the beginning and end of recording, fade-in and fade-out effects can be performed. 1. When stopped or when in recording standby mode, set the operation using the following menu options on the REC sub-menu (see "Operation basics" on page 16). FADE IN? The length of the fade in to the normal level can be set between 1 and 30 seconds in 1-second increments (default setting: 3 seconds). FADE OUT? The length of the fade out into complete silence can be set between 1 and 30 seconds in 1-second increments (default setting: 3 seconds). The display shows Fade Out>XXs or Fade In>XXs. Synchronized recording Synchronized recording basically means that recording will begin automatically when a signal is received, and will stop when the signal ends. Use the SYNC REC key to select the synchronization mode. The synchronization mode determines the automated start and stopping of recording when a signal is received. The SYNC indicator appears on the display. Sync recording 1. While recording standby mode, press the SYNC REC key. 2. Set the signal detection threshold level. Use the SYNC LEVEL option in the REC sub-menu (see "Operation basics" on page 16). Rotate the MULTI JOG dial to adjust the level. The level can be set from -72 dB to -24 dB in 6 dB increments. The default setting is -24 dB. Press the MENU key or push the MULTI JOG dial to enter and return to recording standby mode. 2. In recording standby mode, press the FADER key on the remote control. Recording begins and the sound fades in. After the preset fade-in time, the sound is at normal level. 3. During recording, press the FADER key on the remote control when you wish to fade-out the sound. Fade-out begins with Fade Out flashing on the display then the unit enters recording standby mode. 4. Press the STOP key and the PMA writing will begin. NOTE Fade-in or fade-out function can be operated only by pressing the FADER key on the remote control unit. Starting playback of the source automatically starts recording on the CD-RW901 if Sync function is on (see "Sync recording" below) and manual record start is disabled. 3. Input the source signal. Recording begins automatically when the source signal is detected. The source signal should be higher than the adjusted threshold level. level Start of recording S_LVL Noise level time NOTE After SYNC is set, over one second of silence which is under the adjusted threshold level is required to start recording automatically. Otherwise, the unit does not begin recording even if it is detecting a signal. 27 TASCAM CD-RW901