TASCAM CD-RW901 Owners Manual - Page 28
Sync recording with trim function
![]() |
View all TASCAM CD-RW901 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 28 highlights
5 − Recording When audio signal is not detected for more than five seconds, the CD-RW901 automatically will stop recording and enter record standby mode. level REC ready Five seconds S_LVL time NOTE When the input level drops below the adjusted threshold level for more than five seconds, recording stops automatically and enters in recording ready mode. 3. To cancel the Sync recording mode, press the SYNC REC key. Recording returns to normal and continues till you press the STOP key or the source signal stops. Pressing the STOP key stops recording. The setting remains when the function is set on again. Sync recording with trim function This Sync trim function allows you to override the automatic sync recording where necessary, to chang the start time of the track forwards or backwards. Use the SYNC TRIM option in the REC sub-menu to turn the function on (see "Operation basics" on page 16). Automatic track division The trigger level can also be used to divide tracks if the A_TRACK (auto track) function is enabled. When this function is enabled, the unit automatically inserts a track division in the recorded material. To enable or disable automatic track division: 1. Use A_TRK option in the REC sub-menu to set the mode on. The A.TRACK indicator at the top right of the display lights. 2. Rotate and push the MULTI JOG dial to select and enter the modes following: • DD (digital direct) When recording digitally from MD, CD or DAT, this mode detects a track boundary and divides the track. However, when the DD mode is on, and if the analog source or non-DAT/CD/MD digital connections are detected, the track number will be incremented using 28 TASCAM CD-RW901 NOTE If you set the value so that only high-level signals trigger recording, remember that the start of a piece may not be record as in the diagram. level S_LVL Recordsing starts This part of the track may not be recorded time Also remember that when recording from an analog source, the threshold should be set so that it is higher than the "noise floor". If the "noise floor" is higher than the threshold, a false start will occur: level Start of track is not registered S_LVL Noise is higher than threshold time The available trim range is from -125 through +125 frames. Turn the MULTI JOG dial to adjust the trim value. level detection, as set with the A_TRK LEVEL setting as described here. When AES/EBU is selected, this mode cannot be used. • Level When the sound level has dropped below the threshold for more than two seconds, and sound has re-started, the track will be divided. Use A_TRK LEVEL option in the REC sub-menu. The trigger level is set to -24dB to -72 dB. At least level 2 seconds Track increment A_LVL time
![](/manual_guide/products/tascam-cdrw901-owners-manual-86a0e0d/28.png)