TASCAM DR-10L Owners Manual English - Page 8

ii When recording, slide and hold this switch toward 0REC for about one second to stop recording. NOTE The one-second delay is intended to prevent accidental operation. w PHONES [+]/[−] buttons Use the + and − buttons to adjust the volume output from the headphones jack. During adjustment, a volume indicator will appear on the display. Large Small Top Preparation e 1/8" (3.5mm) mini TRS (with screw lock) IN jack Connect the 3.5mm plug of the mic being used to this unit's IN jack. After connecting it, lock the connector of the mic cable using the jack screw lock. (Tip: MIC (BIAS), Ring: Open, Sleeve: GND) NOTE Avoid excessive force on this connector. Power sources This unit can operate on one AAA battery or USB bus power using the included USB cable. This unit can use an alkaline, Ni-MH or lithium AAA battery. Using a AAA battery Open the battery compartment cover on the back of the unit. Install 1 AAA battery in the compartment with the ¥ and ^ marks as shown. Then, close the battery compartment cover. @ f CAUTION Before connecting headphones, lower the PHONES volume to the minimum level. Failure to do so might cause sudden loud noises, which could harm your hearing or result in other trouble. Do not apply excessive force to the jack when connecting and using headphones. Be careful, because the application of unintended force, particularly when using a mini jack, could damage the equipment. When using a AAA battery, set the type of battery in order to accurately show the amount of power remaining and allow the unit to accurately determine whether power is available for proper operation. (See "Making menu settings" on page 12.) CAUTION •• AAA manganese dry cell batteries cannot be used with this unit. •• This unit cannot recharge AAA Ni-MH batteries. Use a commercially-available recharger. 8 TASCAM DR-10L