TEAC MC-DV600 MC-DV600 Owner's Manual - Page 9

Speaker Connection After all connections are complete, connect the power cord's plug to the AC wall socket. < Read the instructions of each component you intend to use with this unit. < Be sure to connect each plug securely. To prevent hum and noise, do not bundle the connection cords. Subwoofer Before connection Check the impedance of your speakers. Connect speaker with an impedance of 4 Ω or more. How to connect 1. Unlock the lever of the speaker terminal to connect the cable. The black speaker terminals are "_" (negative). Generally, the "+" side of the speaker cable is marked to make it distinguishable from the "_" side of the cable. Connect this marked side to the "+" terminal and the unmarked side to the black "_" terminal. Prepare the speaker cables for connection by stripping off approximately 3/8" (10 mm) or less of the outer insulation. Twist the strands of the stripped wires tightly together: 2. Insert the wire into the terminal fully and lock the lever to securely connect it: CAUTION The metal portions of the two separate wires should not touch or an electrical short can occur. Removing too much insulation may lead to a short circuit if the bared wired should come in contact with each other. Shorted wires can create a fire hazard or induce a failure in your equipment. Make sure none of the wire insulation is inserted into the terminal, only the bare, stripped wire. 3. Make sure it is fastened firmly by pulling the cable lightly. 9