TP-Link EAP110-Outdoor EAP110-OutdoorEU V1 Installation Guide - Page 12
Connect Cables
View all TP-Link EAP110-Outdoor manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
Connect Cables Step 1: Firmly grasp the rear of the interface cover and pull it downward. Step 2: Use an adequate Ethernet cable to connect the LAN port. The length of cable is up to 60m for steady power supply. Shielded CAT5e (or above) cable with an integrated ground wire is recommended. Step 3: Affix the waterproof rubber insert to the underside of the device for waterproofing and replace the cover until it firmly locks into place. 9
9
Connect Cables
Firmly grasp the rear of the interface
cover and pull it downward.
Step 1:
Use an adequate Ethernet cable to
connect the LAN port. The length of
cable is up to 60m for steady power
supply. Shielded CAT5e (or above)
cable with an integrated ground wire
is recommended.
Step 2:
Affix the waterproof rubber insert to
the underside of the device for
waterproofing and replace the cover
until it firmly locks into place.
Step 3: