TP-Link TD-8840 User Guide - Page 30
Enable PPP Debug Mode, Use Static IP Address - firewall
UPC - 845973060176
View all TP-Link TD-8840 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 30 highlights
TD-8840 ADSL2+ Modem Router User Guide Figure 4-6 ¾ PPP Username: Enter your username for your PPPoA connection to identify and verify your account to the ISP. ¾ PPP Password: Enter your password for your PPPoA connection. ¾ Authentication Method: Choose a method of authentication, AUTO, PAP, CHAP, or MSCHAP. ¾ MTU: The default MTU value is 1480 Bytes. It is not recommended that you change the default value unless required by your ISP. The value should be between 512 and 1500. ¾ Dial on demand: If you check this box, the Internet connection can be terminated automatically after a specified inactivity period (Inactivity Timeout) and be re-established when you attempt to access the Internet again. The default value of Inactivity Timeout is 15. The value should be between 1 and 4320. ¾ PPP IP extension: If this box is checked, the IP address obtained by the Router will be assigned to the computer, and the NAT and Firewall will be disabled. ¾ Use Static IP Address: Check this box to use the static IP address to dial. The default value is disabled. ¾ Enable PPP Debug Mode: Check this box to enable the debug mode. The default value is disabled. 24