Toshiba 32A60 Owners Manual - Page 13

Welcome to Toshiba Connecting your TV Using the Remote Control Setting up your TV Using the remote control Preparing the remote control for use With the remote control, you can operate your TV, most VCR models, and cable TV converters together, even if they are different brands. If you will be using your TV with a Toshiba VCR, your remote control is already programmed and ready to use. If you own different brands of VCRs and/or converters, you first have to program your remote control. (See "Programming the remote control for use with a VCR or a cable TV converter" on page 8.) Installing the remote control batteries To install the batteries: 1. Slide the battery cover off of the back of the remote control. 2. Install two "AA" size batteries. Match the + and - signs on the batteries to the signs on the battery compartment. Note: This remote control's functions may or may not operate your VCR or cable TV converter. Refer to the owner's manuals supplied with the equipment to see which features are available. In addition, the original controllers may have features not available on this remote control. If you would like to continue to use these features, you may want to use the original remote control. Caution: • Dispose of your batteries in a designated disposal area. Do not throw your batteries into a fire. • Do not mix battery types or combine used batteries with new ones. • Remove dead batteries immediately to prevent battery acid from leaking into the battery compartment. • If you do not intend to use the remote control for a long time, remove the batteries. RECALL MUTE POWER POWER 3. Slide the battery cover back on to the remote control until the lock snaps. Using the remote control with a VCR or a cable TV converter To control a Toshiba VCR: Set the TV/CABLE/VCR switch to the VCR position. The buttons shown to the right will then control the VCR. The rest of the buttons will operate the TV as usual. To control a cable TV converter: Program the remote control to recognize the brand of your converter (see "Programming the remote control for use with a VCR or cable TV converter," page 8). The shaded buttons shown on the right will control the cable TV converter. Set the TV/CABLE/VCR switch to the CABLE position. 1 2 3 4 5 6 7 8 9 CH RTN 100 0 ENT CH VOL MENU/ VOL ENTER CH TV CABLE VCR EXIT FAV CH TV/VIDEO REC TV/VCR STOP PLAY STILL SOURCE PIP SLOW PAUSE REW FF PIP CH LOCATE SWAP Channel Number Enter Channel TV/Cable/VCR TV/VCR Play Stop Record Fast Forward Rewind Pause Slow Note: Some cable/TV converters may require the ENT key to be pressed after pressing channel numbers. (i.e. 0 - 2 - ENT) Using the TV's Features Appendix Index Reference 7