Toshiba 36AF41 Owners Manual - Page 17

Welcome to Toshiba Connecting your TV Using the Remote Control Setting up your TV Selecting the signal source Use the TV/VIDEO button on the remote control or TV to select the signal source connected to your TV. To change the signal source: Repeatedly press TV/VIDEO to select either TV, VIDEO 1, VIDEO 2, VIDEO 3, or ColorStream. The selected signal source displays in green. TV VIDEO 1 VIDEO 2 VIDEO 3 ColorStream TO SELECT PUSH TV/VIDEO To monitor the signal source: Press RECALL. Programming channels into the TV's memory When you press CHANNEL LM on the TV or remote control, the TV stops only on the channels stored in the TV's memory. Note: To tune the TV to a channel not programmed into the memory, use the CHANNEL NUMBERS on the remote control. Follow the steps below and on the next page to program channels into the TV's memory. Programming channels automatically Your TV can automatically detect all active channels in your area and store them in the TV's memory. After the channels are stored automatically, you can manually add or erase individual channels (see page 18). To program channels automatically: 1. Press MENU. 2. Press x or • to highlight the SET UP menu. 3. Press y or z to highlight TV/CABLE. 4. Press x or • to highlight TV (if you use an antenna) or CABLE (if you use cable). 5. Press z to highlight CH PROGRAM. TV Front Panel TV/Video Channel DEMO MENU TV/VIDEO VOLUME CHANNEL Menu RECALL MUTE o POWER 1 23 4 56 7 89 CH RTN 100 0 ENT CH VOL MENU/ VOL ENTER TV CABLE VCR CH EXIT FAV CH TV/VIDEO A REC TV/VCR STOP PLAY STILL SOURCE PIP SLOW PAUSE REW FF PIP CH LOCATE SWAP CT-90037 POWER RECALL CHANNEL NUMBERS MENU yz x • CHANNEL yz EXIT SET UP LANGUAGE: [ENGLISH] FRANCAIS ESPANOL TV/CABLE: [TV] CABLE CH PROGRAM ADD/ERASE: [ADD] ERASE MORE SET UP LANGUAGE: [ENGLISH] FRANCAIS ESPANOL TV/CABLE: [TV] CABLE CH PROGRAM ADD/ERASE: MORE [ADD] ERASE MOVE [ ] SELECT [ ] MOVE [ ] SELECT [ ] 6. Press x or • to start automatic channel programming ("CH PROGRAM" displays on-screen). The TV automatically cycles through every TV or cable channel (depending on which you selected), and stores all active channels in the TV's memory. 7. When automatic channel programming is complete, the message "CH Programming Completed" appears. 8. Press CHANNEL LM to view the programmed channels. Using the TV's Features Appendix 17 27/32/36AF41(E)