Toshiba 65HM167 Owners Manual - Page 35
Setting the Power-On Mode feature, Viewing the digital signal meter - 3 blinks
UPC - 022265000496
View all Toshiba 65HM167 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 35 highlights
50HM67_EN.book Page 35 Thursday, March 29, 2007 11:28 AM Chapter 5: Setting up your TV Setting the Power-On Mode feature You can select either Power-Saving or Fast mode. If you select Power-Saving mode and you turn off the TV, it can take several seconds for the picture to appear when you turn on the TV again. Power-Saving mode saves more power than Fast mode. See "Specifications" on page 66 for details. If you select Fast mode and the TV is turned off, the TV will stay in Standby mode for several minutes (see Note below). If the TV is turned on from Standby mode, the full picture appears immediately. To set the Power-On Mode feature: 1 Press Y and open the Setup menu. 2 Highlight Power-On Mode and press c. 3 Press b or B to select either Fast or Power-Saving and press T. Setup Installation Sleep Timer PC Settings Power-On Mode Fast Power-Saving Fast Note: If Power-On Mode is set to Fast and you turn off the TV, the following will occur for a few minutes: • The screen (lamp) lights dimly; and • The fans continue to run. This is a function of the Power-On Fast Shutdown mode and is not a TV malfunction. If you do not prefer this, set the PowerOn Mode feature to Power-Saving. When the Power-On Mode feature is set to Power-Saving, if you repeatedly turn the TV on and off in a short period of time, the useful service life of the lamp may be shorter than the average useful service life (- page 63). IMPORTANT NOTICE ABOUT HOT LAMP RESTART When the TV has been powered on long enough for the lamp unit to get hot, it may take several minutes for the picture to appear in the following situations: • When the Power-On Mode feature is set to PowerSaving and you turn the TV off and then on again within a few minutes; or • If the TV is on when a short-term power failure, power surge, or other similar power failure occurs, such that the TV loses and regains power within a few minutes. This is a property of DLP® TV lamp technology and is NOT a sign of malfunction. If this occurs, the yellow LED on the TV front panel will blink (and the blue LED will be lit solid) until the TV is finished restarting the lamp and the normal picture appears. If both LEDs are blinking, you will need to turn the TV off and then on again to restart the lamp. Viewing the digital signal meter You can view the digital signal meter in the ANT digital TV input source only. To view the digital signal meter: 1 Press Y and open the Setup menu. 2 Highlight Installation and press T. 3 A new set of Installation menu icons will appear, as shown below. Open the Terrestrial menu, highlight Signal Meter, and press T. Installation Terrestrial Input Configuration Channel Program Channel Add/Delete Signal Meter 4 Press BbC c to select the antenna input and digital channel whose signal you want to check. Note: The physical digital channel number listed in the Signal Meter screen may not correspond to a virtual TV channel number. Contact your local broadcasters to obtain the RF channel numbers for your local digital stations. Signal Meter Signal Locked 0 Peak 0 Physical Digital Channel Virtual Digital Channel Advanced 4 4-1 Done To close the screen and return to the Terrestrial menu: Highlight Done and press T. To return to normal viewing: Press O. 35 HM67 (E/F) Web 213:276