Toshiba D-VR4SU Owners Manual - Page 15
Power Source - remote control for
View all Toshiba D-VR4SU manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
Parts and functions Inserting Batteries into the Remote Control: 1 Open the battery compartment cover in the direction of the arrow. 2 Pay attention to the polarity diagram in the battery compartment when install two AAA batteries. 3 Close the compartment cover. Introduction Caution: Never throw batteries into a fire. Notes: • Be sure to use AAA size batteries. • Dispose of batteries in a designated disposal area. • Batteries should always be disposed of with the environment in mind. Always dispose of batteries in accordance with applicable laws and regulations. • If the remote control does not operate correctly, or if the operating range becomes reduced, replace batteries with new ones. • When necessary to replace batteries in the remote control, always replace both batteries with new ones. Never mix battery types or use new and used batteries in combination. • Always remove batteries from remote control if they are dead or if the remote control is not to be used for an extended period of time. This will prevent battery acid from leaking into the battery compartment. Remote control basics • Press ON/STANDBY to turn the DVD/VCR on or off. • Press CH or CH to move through the channels, one channel at a time. • The / / / are also used to navigate on-screen menu system. • You can directly access specific channels using numeric keys. • Each press of DVD or VCR, switches the screen between the DVD screen (DVD mode) and the VCR screen (VCR mode). Operation • Aim the remote control at the remote sensor and press control buttons to operate. • Operate the remote control within 30° angle on either side of the remote sensor, up to a distance of approximately 7 meters (23 feet). Approx.7 meters (23 feet) Power Source Wider Hole and Blade AC Outlet Polarized AC Cord Plug (One blade is wider than the other.) 2H5-01 P12-21 15 TO USE AC POWER SOURCE Use the AC polarized line cord provided for operation on AC. Insert the AC cord plug into a standard 120V 60Hz polarized AC outlet. NOTES: • Never connect the AC line cord plug to other than the specified voltage (120V 60Hz). Use the attached power cord only. • If the polarized AC cord does not fit into a non-polarized AC outlet, do not attempt to file or cut the blade. It is the user's responsibility to have an electrician replace the obsolete outlet. • If you cause a static discharge when touching the unit and the unit fails to function, simply unplug the unit from the AC outlet and plug it back in. The unit should return to normal operation. • If the AC cord plug is plugged in for the first time, wait for approximate 3 minutes before operating the unit. 15 7/25/05, 23:18