Toshiba Qosmio G30 PQG31C-HD202E Users Manual Canada; English - Page 284

TOSHIBA RAID Starting, Modifying and Ending the BIOS Setup Program Starting the BIOS Setup Program 1. Switch on your computer while pressing the Esc key. If Password = is displayed, enter the User Password and press the Enter key. Please refer to Chapter 6, the TOSHIBA Password Utility, for details about the User Password. The "Check system. Then press [F1] key." message is displayed. 2. Press the F1 key. The BIOS setup program will start up. Modifying the BIOS 1. Select the RAID ARRAY setting in the SYSTEM SETUP (3/3) screen. Please refer to the operating instructions displayed in the settings screen. 2. The settings are explained as follows. Modify the settings as necessary. Current State Create State Built-in HDD1 Shows the current hard disk status. Modify the hard disk configuration. (Modifications are made with this setting). Status of the connected hard disk. Built-in HDD2 Status of the second hard disk. Configuration status and settings JBOD 1RAID-0 2RAID-0 RAID-1 UNKNOWN No Drive No RAID settings. Windows cannot be installed in this disk except for using recovery CD/DVD. Including RAID settings. Windows can be installed in this disk. Set to RAID-0 for 2 hard disks. This cannot be set in this computer (Current State Only). Set to RAID-1 for 2 hard disks (Current State Only). A RAID status except for the above status and settings (Current State Only). No hard disks connected (Current State Only). G-4 User's Manual