Toshiba R600-SP2801C Maintenance Manual - Page 257
SD board FPC
View all Toshiba R600-SP2801C manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 257 highlights
4.11 Optical disk drive (DVD-Super Multi drive)/SD board 4 Replacement Procedures Installing the optical disk drive/SD board To install the optical disk drive/SD board, follow the steps below and refer to Figure 4-13 to 4-15. 1. Set the ODD FPC, ODD rear plate and ODD side plate to the optical disk drive and secure them with the following screws. • M2×4C S-THIN HEAD ×2 • M2×3B S-THIN HEAD ×1 2. Connect the SD board FPC and ODD FPC to the connectors CN9710 and CN1820 on the SD board. 3. Peel off the double-side tape on the cover assembly. 4. Stick a new double-sided tape and peel off the separator. 5. Stand the optical disk drive and set the SD board with the edge under the guides. 6. Secure the SD board with the following screws. • M2×3B S-THIN HEAD ×4 7. Stick the SD board FPC on the double-sided tape. 8. Set the optical disk drive in place. CAUTION: The laser beam goes out when turning on the power of the computer, because there is no cover on the optical disk drive. The power must be turned off when you remove or install the optical disk drive. 9. Connect the SD board FPC to the connectors CN9700 on the system board. PORTÉGÉ R600 Maintenance Manual (960-709) [CONFIDENTIAL] 4-29