Toshiba R600-SP2801C Maintenance Manual - Page 269
USB board/WL holder
View all Toshiba R600-SP2801C manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 269 highlights
4.17 USB board/WL holder 4 Replacement Procedures 4.17 USB board/WL holder Removing the USB board/WL holder To remove the USB board/WL holder, follow the steps below and refer to Figure 4-23 and 424. 1. Open the insulator and take out the RJ45 wire harness from the slot. 2. Disconnect the USB board FPC from the connector CN9610 on the USB board. 3. Open the insulator (HNS HOLD INSULATOR) and disconnect the sensor harness from the connector CN9620 on the USB board and connector CN9630on the SW board. 4. Disconnect the camera harness from the connector CN9540 on the USB board. 5. Remove the following screw and USB board. • M2×3B S-THIN HEAD ×1 M2x3B S-THIN HEAD Sensor harness Insulator USB board Knob CN9540 CN9620 CN9610 Slot USB board FPC Camera harness Insulator CN9630 RJ45 wire harness Figure 4-23 Removing the USB board/WL holder (1) PORTÉGÉ R600 Maintenance Manual (960-709) [CONFIDENTIAL] 4-41