Toshiba Tecra A8 Maintenance Manual - Page 273
Cover assembly
View all Toshiba Tecra A8 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 273 highlights
4.10 Cover assembly 4 Replacement Procedures 4.10 Cover assembly Removing the Cover assembly To remove the cover assembly, follow the steps below and refer to Figure 4-15 to 4-17. 1. Peel off the insulator and disconnect the SD card slot cable and SW membrane cable from the connector CN9720 and CN9721 on the system board. 2. Disconnect the touch pad cable, fingerprint sensor cable, speaker cable, Bluetooth cable and LCD cable from the connector CN3240, CN9700, CN6170, CN4400 and CN5000 on the system board. 3. Peel off the glass tape and remove the following screw. • M2.5×6B FLAT HEAD screw ×1 LCD cable (Connected to CN5000) Speaker cable (Connected to CN6170) Glass tape M2.5×6B FLAT HEAD Bluetooth cable (Connected to CN4400 Insulator SD card slot cable (Connected to CN9720) SW membrane cable (Connected to CN9721) Touch pad cable (Connected to CN3240) Fingerprint sensor cable (Connected to CN9700) Figure 4-15 Removing the cover assembly (1) TECRA A8 /Satellite Pro A120 Maintenance Manual (960-573) [CONFIDENTIAL] 4-27