Toshiba Tecra M2 Maintenance Manual - Page 99
Modem Troubleshooting, Troubleshooting Procedures, Replacement, Procedures, Replacement Procedures
View all Toshiba Tecra M2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 99 highlights
2.10 Modem Troubleshooting 2 Troubleshooting Procedures Procedure 2 Connector Check and Replacement Check The Modem is installed as a modem daughter card (MDC). If the modem malfunctions, there may be a bad connection between the MDC and the system board. Or the MDC, system board or their connectors might be damaged. Disassemble the computer following the steps described in Chapter 4, Replacement Procedures and perform the following checks: Check 1 Make sure the MDC is firmly connected to PJ3000 on the system board, and the modem/jack cable is connected to PJ3001 on the system board and the connector of the MDC. If a connector is disconnected, connect it firmly and repeat Procedure 1. If the modem is still not functioning properly, perform Check 2. Check 2 The MDC may be defective or damaged. Replace it with a new one following the steps in Chapter 4, Replacement Procedures. If the modem is still not functioning properly, perform Check 3. Check 3 The modem jack or modem/jack cable may be defective or damaged. Replace it with a new one following the steps in Chapter 4, Replacement Procedures. If the modem is still not functioning properly, perform Check 4. Check 4 The system board may be defective or damaged. Replace it with a new one following the steps in Chapter 4, Replacement Procedures. TECRA M2 Maintenance Manual (960-468) 2-45