Tripp Lite 9PXEBM180RT Eaton 9PX 5000 9PX 6000 9PX 6000 G 9PX EMB 180 V Instal - Page 13

ENGLISH 2. Presentation 2.5 LCD description After 5 minutes of inactivity, the LCD displays the screen saver. The LCD backlight automatically dims after 10 minutes of inactivity. Press any button to restore the screen. Operation status Load/equipment status Online mode 50% 2.7kW 3.0kVA 100% 30min 1EBM Efficiency: 95% Battery status Efficiency information The following table describes the status information provided by the UPS Note: If other indicator appears, see troubleshooting on page 38 for additional information. Operation status Standby mode Cause The UPS is Off. Description Equipment is not powered until button is pressed. Online mode The UPS is operating normally. The UPS is powering and protecting the equipment. Battery mode 1 beep every 10 seconds End of backup time 1 beep every 3 seconds High Efficiency mode A utility failure has occured and the UPS is on Battery mode. The UPS is powering the equipment with the battery power. Prepare your equipment for shutdown. The UPS is on Battery mode and the battery is running low. The UPS is operating on High Efficiency mode. This warning is approximate, and the actual time to shutdown may vary significantly. Depending on the UPS load and number of Extended Battery Modules (EBMs), the "Battery Low" warning may occur before the battery reaches 20% capacity. The UPS is powering and protecting the equipment Bypass mode An overload or a fault has occurred, Equipment is powered but not or a command has been received, protected by the UPS. and the UPS is in Bypass mode. 5-6kVA US_EN Page 13