Tripp Lite B0930082E4U Owners Manual for B093- B097- and B098-Series Console S - Page 101
Firewall Rules
View all Tripp Lite B0930082E4U manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 101 highlights
5. Firewall, Failover and OOB Access 5.8.4 Firewall Rules Firewall rules can be used to block or allow traffic through an interface based on port number, the source and/or destination IP address (range), the direction (ingress or egress) and the protocol. This can be used to allow custom on-box services, or block traffic based on policy. To set up a firewall rule: • Navigate to the System: Firewall page and click on the Firewall Rules tab. Note: Prior to firmware version 3.4, this tab was labeled Port Rules and fewer firewall rules could be configured. • Click New Firewall Rule. • Fill in the following fields: Name Name the rule. This name should describe the firewall rule policy being implemented (e.g., block ftp, Allow Tony). Interface Select the interface the firewall rule will be applied to (i.e. Any, Dial-Out/Cellular, VPN, Network Interface, Dial-in etc). Port Range Specify the Port or range of Ports (e.g. 1000 - 1500) the rule will apply to. This may be left blank. Source MAC Address Specify the source MAC address to be matched. This may be left blank. MAC addresses use the format XX:XX:XX:XX:XX:XX, where XX are hex digits. Source Address Range Specify the source IP address (or address range) to match. IP address ranges use the format ip/ netmask (where netmask is in bits 1-32). This may be left blank. Destination Range Specify the destination IP address/range to match. IP address ranges use the format ip/netmask (where netmask is in bits 1-32). This may be left blank. 101