Tripp Lite B0930082E4U Owners Manual for B093- B097- and B098-Series Console S - Page 62
Configure as Server or Client
View all Tripp Lite B0930082E4U manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 62 highlights
4. Serial Port, Host, Device and User Configuration For a server you may also need dh1024.pem (Diffie Hellman parameters). Refer to http://openvpn.net/easyrsa.html for a guide on basic RSA key management. For alternative authentication methods, go to http://openvpn.net/index.php/ documentation/howto.html#auth. For more information, go to http://openvpn.net/howto.html. • Select the Device Driver to be used, either Tun-IP or Tap-Ethernet. The TUN (network tunnel) and TAP (network tap) drivers are virtual network drivers that support IP tunneling and Ethernet tunneling, respectively. TUN and TAP are part of the Linux kernel. • Select either UDP or TCP as the Protocol. UDP is the default and preferred protocol for OpenVPN. • In Tunnel Settings, assign whether this is the Client or Server end of the tunnel. When running as a server, the advanced console server supports multiple clients connecting to the VPN server over the same port. • Check or uncheck the Compression button to enable or disable compression. 4.9.2 Configure as Server or Client Complete the Client Details or Server Details, depending on the Tunnel Mode selected. • If Client has been selected, the Primary Server Address will be the address of the OpenVPN Server. • If Server has been selected, enter the IP Pool Network address and the IP Pool Network mask for the IP Pool. The network defined by the IP Pool Network address/mask is used to provide the addresses for connecting clients. Click Apply to save changes. 62