Tripp Lite USA-19HS Owner's Manual for Windows v3.4 USA-19HS USB Serial Adapte - Page 26

Keyspan:USB Serial Adapter for Windows-v3.4 Manual 7.1.c.01 - Palm Desktop Before you begin... This Configuration Example assumes that you have already done the following: 1. installed the Keyspan serial port hardware and software 2. installed the Palm Desktop software 3. connected the Palm Serial Cradle hardware to a Keyspan serial port If you have not performed any of the steps mentioned above, please do so before proceeding. Step 1 - Check the Keyspan Serial Assistant Before proceeding, you should check to see if the Keyspan serial port is installed correctly. To do this, open the Keyspan Serial Assistant (in Start menu -> Programs -> Keyspan USB Serial Adapter -> Keyspan Serial Assistant). When you open the Keyspan Serial Assistant, you will see a window similar to the one shown below: the Keyspan Serial Assistant window If your Keyspan hardware and software are installed correctly, you will see your adapter in the 'Adapter Status' tab box. You should also see the COM port number (ie COM1, COM2, etc.) and the COM Port Status.(IDLE or BUSY). If you see either of these messages, note the Keyspan COM port number (ie COM1, COM2, etc.) and its COM Port Status.(IDLE or BUSY). Proceed to Step 2. If you do not receive either of these messages, proceed Problem Solving section in your Keyspan Rev 03jul13 This User Manual applies to the Keyspan USB Serial Adapter Software for Windows. Page 26