Uniden BC-RH96 English Owners Manual - Page 25
Initialize Memory (Reset), Using the Cable Clamp, to your target scanner. - remote cable
View all Uniden BC-RH96 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 25 highlights
Initialize Memory (Reset) Using the Cable Clamp To reset the BC-RH96 to factory default settings, follow the sequence below. Note that once done, there is no undo and all programmed keys are reset. A self-adhesive clamp/ guide is provided to assist you to safely route the Remote Cable With the unit off, press and hold the following keys and turn on power at the same time: [2], [9] and [HOLD].You see the reset screen below. If you turn off power during reset, the process starts again when you next #NN/GOQT[%NGCT turn on the unit. 2NGCUG9CKV to your target scanner. Clean the planned location, peel the base covering, and firmly press it on the scanner. Then route the Remote Cable through the guide. This helps assure that the remote Cable will not come out of the special connector on either a Mobile of Handy scanner. 25