Uniden BC250D English Owners Manual - Page 84
Remote Interface - remote mode
View all Uniden BC250D manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 84 highlights
Remote Interface You can communicate and program your BC250D in numerous ways with peripheral devices using the Remote Interface Cable port. This radio offers the following modes: ❖ PC Control Mode Program and control your scanner from a PC using Uniden's E-Scanner software. ❖ Clone Mode Clone all the frequencies, trunking talkgroups, and fleet maps programmed into your scanner to another BC250D scanner or BC785D. PC Control Mode To connect Scanner to PC: CH/ FRQ HOLD/ MAN RSM SCAN SERVICE SEARCH MENU/BACK TRUNK L/O REVERSE . SELECT E Plug the smaller end of the supplied Remote Interface Cable into the remote port in accordance with the direction of the mark which is on the right side of the scanner. Plug the other end of the cable (DB-9 serial connector) into a personal computer's serial port. A few PC's may require an adapter, most will not. Of course, make sure your PC is turned ON. To program your scanner: You can program and control your scanner remotely from a PC using Uniden's E-Scanner software. After connecting the scanner to a PC, turn the scanner ON. To use the Remote (PC Control) mode, you must install Uniden's E-Scanner software and use as directed. Make sure that your scanner is connected to the serial port of the PC using the Remote Interface Cable. 80