Uniden BC75XLT English Owner's Manual - Page 24

Installing Rechargeable 2300mAh Ni-MH Batteries

Get Uniden BC75XLT PDF manuals and user guides View all Uniden BC75XLT manuals
Add to My Manuals
Save this manual to your list of manuals

Page 24 highlights

Inside the battery compartment is a switch; set the unit to either ALK or Ni-MH to match the type of battery you're using. Warning! Non-rechargeable batteries can get hot or burst if you try to charge them. Cautions: • When flashes in the display and the scanner beeps every 15 seconds, recharge or replace the batteries. • Use only fresh batteries of the required size and recommended type. • Always remove old or weak batteries. Batteries can leak chemicals that destroy electronic circuits. • Do not mix old and new batteries, different types of batteries (standard, alkaline, or rechargeable), or rechargeable batteries of different capacities. Installing Non-Rechargeable Batteries 1. Make sure the power is turned off. 2. Slide the battery compartment cover off. 3. Use a pointed object such as a ballpoint pen to set the battery selection switch inside the compartment to ALK. 4. Insert the batteries as indicated by the polarity symbols (+ and -) marked inside the battery compartment. 5. Replace the battery compartment cover. Installing Rechargeable 2300mAh Ni-MH Batteries You can also use two Ni-MH rechargeable batteries to power your scanner. 24

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
24
Inside the battery compartment is a switch; set the unit to
either
ALK
or
Ni±MH
to match the type of battery you’re
using.
WARNING!
Non-rechargeable batteries can get hot or
burst if you try to charge them.
CAUTIONS:
•
When
flashes in the display and the scanner
beeps every 15 seconds, recharge or replace the
batteries°
•
Use only fresh batteries of the required size and
recommended type°
•
Always remove old or weak batteries° Batteries can
leak chemicals that destroy electronic circuits°
•
Do not mix old and new batteries, different types of
batteries (standard, alkaline, or rechargeable), or
rechargeable batteries of different capacities°
Installing Non-Rechargeable Batteries
1.
Make sure the power is turned off.
2.
Slide the battery compartment cover off.
3.
Use a pointed object such as a ballpoint pen to set the
battery selection switch inside the compartment to
ALK
.
4.
Insert the batteries as indicated by the polarity symbols
(+ and -) marked inside the battery compartment.
5.
Replace the battery compartment cover.
Installing Rechargeable 2300mAh Ni-MH Batteries
You can also use two Ni-MH rechargeable batteries to power
your scanner.