Uniden BC75XLT English Owner's Manual - Page 53

Care And Maintenance - reset

Get Uniden BC75XLT PDF manuals and user guides View all Uniden BC75XLT manuals
Add to My Manuals
Save this manual to your list of manuals

Page 53 highlights

Care and Maintenance Resetting the Scanner If the scanner's display locks up or stops operating properly, you might need to reset the scanner. CAUTION: This procedure clears all the information you have stored in the scanner. Before you reset the scanner, try turning it off and back on to see if it begins working properly. Reset the scanner only when you are sure it is not working properly. 1. Turn off the scanner. 2. While holding down 2, 9, and Hold, turn on the scanner. It takes about 3 seconds to initialize and CLEAr appears. General Use • Turn the scanner off before disconnecting the power. • Always write down the programmed frequencies in the event of memory loss. • If memory is lost, simply reprogram each channel. The display shows 000.0000 in all channels when there has been a memory loss. • Always press each button firmly until you hear the entry tone for that key entry. Location • Do not use the scanner in high-moisture environments such as the kitchen or bathroom. • Avoid placing the unit in direct sunlight or near heating elements or vents. 53

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
53
CARE AND MAINTENANCE
RESETTING THE SCANNER
If the scanner’s display locks up or stops operating properly,
you might need to reset the scanner.
CAUTION: This procedure clears all the information
you have stored in the scanner° Before you reset
the scanner, try turning it off and back on to see if
it begins working properly° Reset the scanner only
when you are sure it is not working properly°
1.
Turn off the scanner.
2.
While holding down
2
,
9
, and
Hold
, turn on the scanner.
It takes about 3 seconds to initialize and
CLEAr
appears.
GENERAL USE
•
Turn the scanner off before disconnecting the power.
•
Always write down the programmed frequencies in the
event of memory loss.
•
If memory is lost, simply reprogram each channel. The
display shows 000.0000 in all channels when there has
been a memory loss.
•
Always press each button firmly until you hear the entry
tone for that key entry.
LOCATION
•
Do not use the scanner in high-moisture environments
such as the kitchen or bathroom.
•
Avoid placing the unit in direct sunlight or near heating
elements or vents.