Uniden BEARTRACKER 885 English Owners Manual - Page 14

Connecting the Power Cords Uniden recommends connecting the power lead to the Ignition Switch Accessory Terminal. This way, the transceiver is automatically turned off when the ignition switch is turned off. As an alternative, the power cord may be connected to an available terminal on the fuse block or to a point in the wiring harness. However, caution must be taken to prevent a short circuit. If in doubt, contact your vehicle dealer for information. Ground Information This transceiver may be installed and used in any 12-volt DC negative ground system vehicle. Negative Ground System With a negative ground system, the negative (-) battery terminal is usually connected to the vehicle motor block. Connect the red DC power cord from the transceiver to the positive (+) battery terminal or other convenient point. Then connect the black power cord to the vehicle chassis or negative (-) battery terminal. MARINE INSTALLATION Consult your dealer for information regarding marine installation. It is important to adequately ground the system to prevent electrolysis between the fittings in the hull and the water. SET UP BEARTRACKER 885 BEARTRACKER 885 INITIAL SETUP 1. Remove SD card. 2. Install the GPS unit. 3. Insert the SD card into your computer (you may need an SD card to USB adapter, not included). Update the database according to E-14