Uniden BEARTRACKER 885 English Owners Manual - Page 17

To Do This... Listen to public safety channels Decrease squelch so more CB signals can get through Adjust scanner's squelch level Set which mode has priority for voice signals Eliminate/reduce noise caused by your vehicle's electrical system Change the LCD from day mode to night mode Check/calibrate the antenna Do this... Press a public safety key on the radio. (See item #5 on page 9 and key descriptions on page 19.) Adjust the squelch knob (see page 15). See page 23 for procedures. Set Audio Priority in Menus (see page 25). Check Automatic Noise Limiter and Noise Blanker levels (see page 18). Make this change using the Function key and 9/19|Day/Night key (see page 22). See page 26 for procedures. USING THE KEYS SRF/CAL/SWR Key This key checks incoming signal strength and received signal power or allows you to tune your antenna for best performance. See page 26 for operation details. CB/PA/WX|WX ALT Key This key lets you switch between CB, PA, and Weather modes. Enable/ disable the Weather Alert function using the Function key (see page 21). 1. Press the key once. CB is enabled. SCAN scrolls under the channel number. 2. Press the key again. PA is enabled and PA displays on the LCD. When you key the mic, PA replaces the channel number and audio goes to the PA speaker only. As long as the radio is in PA mode, any CB or scanner audio goes to the PA speaker. 3. Press the key a third time. Weather mode is enabled. WX displays on the LCD and the weather channel frequency number displays under the channel number. You can hear local weather E-17