Uniden BEARTRACKER 885 English Owners Manual - Page 28

Preventive Maintenance, Maintenance, Troubleshooting - problems

Get Uniden BEARTRACKER 885 PDF manuals and user guides View all Uniden BEARTRACKER 885 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 28 highlights

database is being updated. When the update is complete, SCAN displays. PREVENTIVE MAINTENANCE Every six months: 1. Check the SWR. 2. Be sure all electrical connections are tight. 3. Inspect antenna coaxial cable for wear or breaks in shielding. 4. Be sure all screws and mounting hardware are tight. MAINTENANCE The BearTracker 885 is designed to give you years of trouble-free service. There are no user-serviceable parts inside. It requires no maintenance except replacing the inline fuse in the fuse holder of the DC power cord. To replace a blown fuse: 1. Press ends of the fuse holder together. Twist to open. Carefully separate the two pieces. 2. Remove the fuse and inspect. If blown, replace with the same type 6-amp fuse. Use only the fuse specified for your BearTracker 885. Failure to do so may void your warranty. TROUBLESHOOTING In the event of system malfunction, perform the following procedures: Problem Unit does not power up No reception Suggestion Check power cord connections. Check fuse. Check vehicle electrical system. Check microphone connection. Set CB/PA to CB. Check VOLUME and SQUELCH. Check antenna. Check antenna connection. Adjust RF Gain. E-28

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
E-28
database is being updated. When the update is complete,
SCAN
displays.
PREVENTIVE MAINTENANCE
Every six months:
1.
Check the SWR.
2.
Be sure all electrical connections are tight.
3.
Inspect antenna coaxial cable for wear or breaks in shielding.
4.
Be sure all screws and mounting hardware are tight.
MAINTENANCE
The BearTracker 885 is designed to give you years of trouble-free service.
There are no user-serviceable parts inside. It requires no maintenance
except replacing the inline fuse in the fuse holder of the DC power cord.
To replace a blown fuse:
1.
Press ends of the fuse holder together. Twist to open. Carefully
separate the two pieces.
2.
Remove the fuse and inspect. If blown, replace with the same
type 6-amp fuse.
Use only the fuse speciļ¬ed for your BearTracker 885. Failure to
do so may void your warranty.
TROUBLESHOOTING
In the event of system malfunction, perform the following procedures:
Problem
Suggestion
Unit does not power up
Check power cord connections.
Check fuse.
Check vehicle electrical system.
No reception
Check microphone connection.
Set
CB/PA
to
CB
.
Check
VOLUME
and
SQUELCH
.
Check antenna.
Check antenna connection.
Adjust
RF Gain
.