Uniden DXI8560-2 English Owners Manual - Page 3

8 Place one handset in the base and the other in the charging cradle. Make sure that the /in use and LEDs illuminate. What if the charge LED doesn't light up? • Check AC adapter connection. • Make sure you are not using an outlet that's controlled by a wall switch. Note: For optimum battery life, charge all of your handsets completely before you connect the telephone cord. The first time you charge a new battery, allow 15 to 20 hours. 1-4. Connect the Telephone Cord 9 Connect the telephone cord to the TEL LINE jack on the rear of the base. 10 Connect the telephone cord to a telephone wall jack. To TEL LINE To telephone wall jack Telephone cord (supplied) Note: If the telephone cord does not fit into your telephone wall jack, contact your local phone provider for assistance. If you receive high-speed internet service through your telephone line (referred to as DSL), you should install a DSL filter between the telephone base and the wall jack. Standard telephones often can't operate correctly without a DSL filter. Test the connection Telephone cord 11 Pick up the handset from the base and press [TALK/flash]. You should hear a dial tone, and the display should show TALK. DSL filter Telephone wall jack Talk 0:01 What if I can't hear a dial tone? Check the telephone cord connection on the base. What if the display doesn't show TALK? Put the handset back in the base for at least five seconds. Make sure the /in use LED flashes. 12 Make a quick test call, and then press [END] to hang up. What if the call doesn't go through? Check to see if your telephone provider uses pulse dialing. (See section 3-1 on System Options.) What if there is a lot of static? Check the sources of interference described in section 1-1 on Choosing the best location: is the base near any of those? 1-5. Register the Accessory Handsets 13 One by one, put each additional handset in the base. The /in use LED should flash as the base recognizes the handset. What if the /in use LED doesn't flash? Pick the handset up and put it back in the base. 14 Wait at least five seconds, then pick up the handset and press [TALK/flash]. Make sure you can get a dial tone on each handset. 1-6. Things to Remember • When you charge the handsets, the Caller ID summary screen and the name of the handset appear in the display. • Lots of people put HANDSET #1 in the base, but it doesn't matter which handset you put in the base and which one you put in the charging cradle. HS1 New :01 Total:17 Now your phone is ready to use! 1-7. Attach the Belt Clip To attach the belt clip Insert the tabs on the side of the belt clip into the holes on either side of the handset. Press the belt clip down until it clicks into place. (Tug on the clip to make sure it's secure.) To remove the belt clip Gently pull the tabs out of the holes, then slide the belt clip off of the handset.