ViewSonic LS700-4K User Guide - Page 33

Switching input signal, Source, Enter

Get ViewSonic LS700-4K PDF manuals and user guides View all ViewSonic LS700-4K manuals
Add to My Manuals
Save this manual to your list of manuals

Page 33 highlights

Switching input signal The projector can be connected to multiple devices at the same time. However, it can only display one full screen at a time. Please press the signal [Source] button on the remote control to search for the available input signals. Then select the desired signal. 1. Press [Source] to display the source selection column. 2. Keep pressing the / until you arrive at the desired signal, then press [Enter]. Once the signal source is detected, the green dot near the available signal source icon will light up. For display resolutions of this projector, please refer to "Projector specifications". To achieve the best image display effects, you should select and use an input signal that outputs at this resolution. Any other resolutions will be scaled by the projector depending upon the aspect ratio setting, which may cause some image distortion or loss of picture clarity. See "Select the aspect ratio" for details. 26

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
26
Switching input signal
The projector can be connected to multiple devices at the same time. However, it can
only display one full screen at a time.
Please press the signal [
Source
] button on the remote control to search for the
available input signals. Then select the desired signal.
1.
Press [Source] to display the source selection column.
2.
Keep pressing the
/
until you arrive at the desired signal, then press [
Enter
].
Once the signal source is detected, the green dot near the available signal source
icon will light up.
For display resolutions of this projector, please refer to
“Projector specifications”
.
To achieve the best image display effects, you should select and use an input signal that
outputs at this resolution. Any other resolutions will be scaled by the projector depending upon
the aspect ratio setting, which may cause some image distortion or loss of picture clarity. See
“Select the aspect ratio”
for details.