ViewSonic LS700-4K User Guide - Page 46
Control the projector through the local area network, Network Settings
View all ViewSonic LS700-4K manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 46 highlights
Control the projector through the local area network This projector supports Crestron® software. After correct settings in the wired local area network menu are finished, the projector can be managed on the computer with the browser when the computer and the projector are correctly connected to the same local area network. (Example of connection) Configure the wired local area network If you are in a DHCP environment: 1. Connect one end of the RJ45 cable to the RJ45 local area network input jack of the projector, and connect the other end to the RJ45 port. 2. Open the OSD menu and enter the Network Settings. 3. Select DHCP and then press / to select On. 4. Press to select the Apply and then press [Enter]. 5. Please wait for about 15-20 seconds and then re-enter the page of the wired local area network. The IP address, subnet mask, default gateway and DNS server settings will be displayed. Please remember the IP address displayed in the IP address. If the IP address still does not display, contact the network administrator. If the RJ45 cable is not correctly connected, the IP address, subnet mask, default gateway and DNS server settings will be displayed as 0.0.0.0. Make sure the cable has been correctly connected and re-execute the above steps. To connect to the projector when the projector is in the standby mode, set the Network Settings > Wired LAN > Standby LAN Control to On. 39