Viking DDSF136DSS Installation Instructions - Page 16
Replace Base Grille, Door Height Adjustment
View all Viking DDSF136DSS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 16 highlights
Installation Instructions 3. Adjust the rear leveling bolt to bring the refrigerator level with the side cabinets or cabinet end panels. 4. If you want, you may now use the four leveling bolts to raise the refrigerator to reduce the gap between the refrigerator top hinge and the cabinet opening. Check that all four leveling legs still touch the floor and that the cabinet doors above the refrigerator open all the way. Replace Base Grille 1. Open the refrigerator doors to 90°. 2. Replace the base grille. Place the lower clips into the bottom of the refrigerator and roll the grille up until it snaps into place. Door Height Adjustment TOOLS NEEDED: 5⁄16" or adjustable wrench. IMPORTANT: Models are preset with a quarter's-thickness difference in door height and may not need adjusting. If necessary after the refrigerator is loaded with food, follow the steps below to adjust the door height up or down. 1. Locate the height adjustment bolt on the bottom hinge of the refrigerator door. NOTE: For easier access to the height adjustment bolt, the refrigerator door should be closed. 2. Turn the height adjustment bolt using the 5⁄16" or adjustable wrench. • To raise the height, turn the bolt to the right. • To lower the height, turn the bolt to the left. 3. Check to make sure the doors are even at the top and bottom. If necessary, continue to turn the height adjustment bolt. 14