Viking DDSF136DSS Installation Instructions - Page 17

Installation Instructions Complete Installation 1. Turn water supply line valve to "Open" position. 2. Turn refrigerator switch to ON position. Wait a few minutes. Check water line connections for leaks. 3. Set refrigerator and freezer compartment controls to the midpoint setting. Check that the compressor is operating properly and that all lights are working. 4. Flush water system before using. See "Prepare the Water System." NOTE: If construction will continue after refrigerator has been installed, set controls to OFF. If refrigerator does not operate • Check that the circuit breaker is not tripped or household fuse blown. • Check that the power supply cord is plugged into a grounded 3 prong outlet. • See "Troubleshooting" in the Use & Care Guide. Performance Checklist • Plug in refrigerator and verify operation. • Connect water supply (if applicable). • Verify ice maker bail arm is down. • Verify dispenser operation (if applicable). • Align/square door(s). • Verify drain pan properly installed and no leaks on water connection. • Remove internal packaging and labels and wipe product down. Installer's Information: Installer's name Installer's company Service and Registration Only authorized replacement parts may be used in performing service on the appliance. Do not repair or replace any part of the appliance unless specifically recommended in the manual. All other servicing should be referred to a qualified technician. Record the information indicated below. You will need it if service is ever required. The model and serial numbers are listed on a label on the inside wall of your refrigerator. Model number Serial number Purchase date Installation date Dealer name Address 15