Viking FDW100 Installation Instructions - Page 10

Installation • After installing one clip for each side, push the dishwasher into the cabinet (Figure E). • Note that while pushing the dishwasher into the cabinet, water supply hose must move in the channel to the front (Figure F). • Fix the second clip (Figure G). Installation Water supply may be connected to the dishwasher in one of two ways: • With metal braided hose. • With copper tubing. CAUTION • Hot water supply line: Use minimum 3/8" O.D. copper tubing or metal braided dishwasher supply line. • Temperatures required for soldering and sweating will damage the dishwasher's water inlet valve so if any such operation is needed, keep the heat source min. 7-7/8" (20.0cm) away from the dishwasher's water inlet valve. • There should not be any sharp bends in the water line that may restrict the water flow. • Teflon tape or pipe thread compound must be used for sealing the connection. Before connecting the copper water supply line to the dishwasher, flush it with hot water to clear any foreign material. NOTICE After connections are made, turn on the water supply to check for leaks. 17 18