Viking FDW100WS Installation Instructions - Page 5

General Information Materials Which May Be Needed Hot Water Supply Line - Minimum 3/8" O.D. copper tubing or metal braided dishwasher supply line. 90° elbow with 3/8" N.P.T. male threads on one leg, and sized to fit your water supply line (copper tubing/compression fitting, or braided hose) on the other leg. UL listed conduit connector or strain relief. Teflon tape or other pipe thread compound to seal plumbing connections. Shut-off valve and fittings appropriate for hot water supply line (copper tubing/compression fitting, or braided hose). Silicone. Glue. 7 General Information Parts Supplied Parts for your dishwasher will come in several plastic bags. Check your parts bags to make sure you have all the parts as listed below. Materials Supplied Dishwasher Parts Bag 1 Dishwasher Parts Bag 2 a. x1 This dishwasher bag comes with v. Screws Ø 1/8"x5/8" b. x1 the following parts: (Ø 3.5mmx14mm) a. Side Trim Strips - Left y. Screws Ø 3/16"x1-3/4" c. x1 b. Side Trim Strips - Right (Ø 4mmx43mm) c. Adjusting Wrench d. x6 d. Screws Ø 1/8"x5/8" Parts Attached to the Rear e. x1 (Ø 3.5mmx14mm) e. Mounting Bracket - Left of the Dishwasher a. Side Trim Strips - Left f. x1 f. Mounting Bracket - Right b. Side Trim Strips - Right g. Spring Clamp o. Kickplate g. x1 h. Screw Clamp (Kickplate without slots) j. Rubber Connector p. Kickplate h. x1 k. Kickplate Bracket - Left l. Kickplate Bracket - Right j. x1 m. Edge Protector n. Clips k. x1 o. Kickplate (kickplate without slots) l. x1 p. Kickplate m. x1 r. Screws Ø 1/8"x3/8" (Ø 3.9mmx9mm) s. Plastic Caps n. x2 t. Screws Ø 3/16"x1/4" (Ø 4mmx6mm) o. x1 z. Steam Protection Foil p. x1 r. x2 s. x2 t. x2 v. x4 y. x4 z. x1 8