Viking FDW100WS Installation Instructions - Page 6

Specifications (612.40"cmmamx ax) (61.024c"mmmaxax) (6214.0" cmmaxmax) Built-In Dishwasher Overall Width Overall Height from Floor Overall Depth from Rear Cutout Width Cutout Height Cutout Depth Electrical Requirements Water-Heating Element Rating Inlet Water Temperature Inlet Water Pressure Operating Range Inlet Water Hose Drain Hose Drain Hose High Loop Required Approximate Shipping Weight 23-9/16" (59.8 cm) 33-7/8 (86.0 cm) min. to 35-7/8" (91.1 cm) max. without door panel - 21 5/8" (54.9 cm) with door panel - 22 3/16" (156.4 cm) 24" (61.0 cm) 34" (86.4 cm) min. to 36" (91.4 cm) max. 24" (61.0 cm) 12.0 amps, 120V/60 Hz; 4' (1.2 m) electrical cord supplied with unit 1240 watts 120°F (49°C) required 4.35 to 145 psi (.3 - 10 bar) Minimum 3/8" OD copper tubing or braided metal water line required. 6.4' (1.9 m) drain hose provided Height from floor - 28" (71.1 cm) 97 lbs. (44 kg) NOTICE Because we continually strive to improve our products, we may change our specifications and design without prior notice. This device corresponds to the following directives: UL 749 Household Dishwasher Directive. 9 Enclosure Preparation Electrical Preparation WARNING The dishwasher is designed for an electrical supply of 120V, 60Hz, AC, connected to a dishwasher-dedicated, properly grounded electrical circuit with a fuse or breaker rated for 15 amperes. Preparation for Installing Mounting Brackets WARNING Dishwasher must be secured to adjacent cabinetry using the mounting brackets provided. Failure to do this may cause damage to property or bodily injury. • Place the two mounting brackets into the top corners of the dishwasher. • Fix the mounting brackets (A) to the top corners of the dishwasher, with the screws supplied. • Bend sides of mounting brackets (B) in order to fix from sides (if necessary). Adjusting Height If the height of the enclosure is 33-7/8" to 35-7/8" (86.1cm-91.1cm), adjust supports as shown in the figure. Supplied (4) 10