Vivitar DVR 990HD Camera Manual - Page 7

Section 2 Getting Started Loading the Battery Before using the camera, you must load the Lithium-ion rechargeable battery come within the package. 1. Insert the battery according to the correct polarity marks ( + or -). 2. Close the battery cover firmly. Charging the Battery You must use the supplied AC charger or the USB cable. The camera must be turned OFF. The blinking light confirms the camera is currently charging, and the light becomes constant after the charging is completed. In AC charging Mode, the light will turn itself off automatically after 3~5 minutes . The full charge time is about 4 to 5 hours. (Actual charging time may vary. It depends on the battery conditions.) Inserting and Removing an SD Card (Optional) The camera comes with an internal memory that allows you to store photos and videos. You can expand the memory capacity by using an optional SD memory card. 1. Insert the memory card into the slot. Please refer to the figure on the right side. 2. To remove the installed SD card, press the card inward to release it. 3. When the card pops out, gently remove it from its slot. 4. Recommended memory capacity: 1GB or above. Note • When a memory card is fitted, videos/photos are saved to the card rather than the built-in memory. • Protecting Data on an SD Card: SD Card is read-only when it is locked. No photos or videos can be recorded when the SD card is locked. Make sure the lock is on the writeable position before recording any media. Writeable position Write-Protected Position EN 7