Vizio P50HDM User Manual - Page 6

VIZIO P50 HDM User Guide Electrical Warnings Do not place this product in a location that is subject to heavy vibration, or on an unstable surface such as an inclined surface. The product may fall off or fall over, causing injuries. When moving the product, be sure to turn off the power and leave 5 seconds then disconnect all the cables. While moving the product, watch your step. The product may be dropped or fall, leading to injuries of electric shock. This product should be moved by two or more persons. If one person attempts to carry this product alone, he/she may be injured. This product contains glass. The glass may break, causing injuries, if shock, vibration, heat, or distortion is applied to the product. This product may be damaged if it is subject to excessive stresses (such as excessive voltage, current, or temperature). The absolute maximum ratings specify the limits of these stresses. Do not switch AC power on/off in the short time, be sure to turn off the power and leave 5 seconds then AC power on. If this product is used as a display board to display a static image, "image sticking" occurs. This means that the luminance of areas of the display that remain lit for a long time drops compared with the luminance of areas that are lit for a shorter time, causing uneven luminance across the display. The degree to which this occurs is in proportion to the luminance at which the display is used. To prevent this phenomenon, therefore, avoid static images as much as possible and design your system so that it is used at a low luminance, by reducing signal level difference between bright area and less bright area through signal processing. Within the warranty period, general faults that occur due to defects in components such as ICs will be rectified by LGE without charge. However, IMAGE STICKING is not included in the warranty. Repairs due to the other faults may be charged for depending on responsibility for the faults. In case of AC PDP driving mechanism, because the brightness of output is not always proportional to input signals. Therefore the nonlinearity of gray can occasionally be observed in certain gray levels as well as Contour and Error Diffusion Noise can be appeared when a dark picture is on the screen especially. These are phenomena that can be observed on the PDP driving mechanism. With simple adjustment to picture brightness control, these can be reduced considerably. Because of the need to control the power consumption on the PDP driving mechanism, the APL (Average Picture Level) mode was equipped. Thus, as the picture on the screen changes, there can be slightly switched in brightness. This also is a phenomenon that can be observed on the PDP driving mechanism. HDMI™ Warnings If you hot-plug the HDMI™ cable, the signal will be unstable for about 2 to 5 seconds. Only supports timing 640x480 @60Hz DVI Version - 5/24/2005 5 www.vizioce.com