Home » Vtech Manuals » Cordless Phones » Vtech VT 2417 » Manual Viewer

Vtech VT 2417 User Manual - Page 14

Headset Operation - cordless

UPC - 735078005281

Add to My Manuals
Save this manual to your list of manuals

Page 14 highlights

Headset Operation Your VT2418 Handset is equipped with a 2.5mm Headset Jack for use with an optional accessory Headset for hands-free operation. If you choose to use the Headset option, you must obtain an optional accessory Headset, which is compatible with the VT2418. To purchase a Headset, call VTECH Customer Service at 1-800-595-9511. Once you have a compatible 2.5mm Headset, locate the Headset Jack on the VT2418 Handset. Connect the plug on the Headset cord to the jack on the cordless Handset. The plug should fit securely. Do not force the connection. NOTE : Whenever a compatible Headset is connected to the cordless Handset, the microphone on the Handset will be muted. This is done to limit the effect of background noise. Many compatible Headsets have a reversible, monaural design. You can wear your Headset on either ear, leaving one ear free for room conversation. Belt Clip The VT2418 is also equipped with a detachable belt clip. Align the pins on the inside edge of the clip with the notches on the sides of the Handset. The belt clip should snap securely into place. Do not force the connection. 13 Additional Information

Section	Page
Table of Contents	1
Important Safety Instructions	2
Introduction	3
Parts Check List:	3
Handset and Base Layout	4
Getting Started	5
Setup	5
Connecting power to Base Unit	5
Installation of Battery Pack in Handset	5
Connecting to phone line	6
Checking for dial tone	6
Tone/Pulse Selection	6
Wall Mounting	7
1. Choose a spot near an electrical outlet and a telephone jack.	7
2. Mount the base on the wall.	7
3. Connect the telephone cord.	7
4. Connect the power cord.	7
Handset Features	8
IN USE/LOW BATT LED	8
PHONE / FLASH KEY	8
REDIAL / PAUSE KEY	8
TONE/ * KEY	8
PROG KEY	8
VOLUME CONTROL	8
OFF KEY	8
CHAN KEY	8
MEM KEY	8
Base Unit Features	9
IN USE/ CHARGING LED	9
PAGE KEY	9
Basic Operation	10
Operating Instructions	10
Making Calls	10
Answering Calls	10
Disconnecting	10
Changing Channels	11
TONE/PULSE Setting	11
Temporary Tone	11
Programming the Ringer Type	11
Turning Off the Ringer	11
Checking the Ringer	12
Memory Dialing	12
Programming Speed Dial Numbers	12
Speed Number Dialing	12
To Change or Replace a Speed Dial Number	12
Storing Pauses in Memory	13
Using Redial	13
Storing a Redial Number into Speed Dial	13
The Page Feature	13
Additional Information	14
Headset Operation	14
To purchase a Headset,	14
Belt Clip	14
Maintenance	15
In Case Of Difficulty	16
The Phone Doesn't Work At All	16
No Dial Tone	16
You Get Noise, Static, Or A Weak Signal Even When You're Near The Base Unit	16
You Get Noise, Static, Or A Weak Signal When You're Away From The Base Unit	16
The Handset Does Not Ring When You Receive A Call	16
You Hear Other Calls While Using Your Phone	16
You Hear Noise In The Handset, And None Of The Keys Or Buttons Work	17
Common Cure For Electronic Equipment	17
Warranty Statement	18
FCC, ACTA and IC Regulations	21
The RBRC® Seal	24