Waring MX1200XTX Instruction Manual - Page 4

6. Allow motor to come to a complete stop before removing container from blender base. Never place the container on the motor base or remove it from the motor base while motor is running. 7. Always hold container with one hand when starting and while blending. Never operate without jar lid. 8. Wash and dry container after each use. See Cleaning and Sanitizing Instructions. 9. To turn unit off, press STANDBY button. Green LED light will go off. MX ELECTRONIC TOUCHPAD SWITCHES WITH TIMER 1. Before starting, make sure that the blender is unplugged and container is not positioned on the blender. 2. Put ingredients into container and cover it. Do not fill above MAX line. 3. Place container on blender base. Be sure container is fully seated and that drive coupling is properly engaged. Plug blender cord into outlet. 4. This blender is equipped with an electronic membrane keypad. The keypad has a main power STANDBY button, plus HI , LO , STOP and PULSE buttons and a 30-second countdown timer with up and down arrows to set time. 5. Press the STANDBY button to turn on the blender. Green LED will illuminate. The electronic timer will indicate 10 seconds (default). Press the up or down arrow to set the desired time. The electronic timer will indicate run time in 5-second intervals up to a maximum of 30 seconds. After the desired time is set, press HI or LO to start the blender. The timer will count down to 0 in 1-second intervals and blender will shut off. Pressing the PULSE button, the STOP button or the STANDBY button will override the timer and the blender will stop regardless of time left on timer. NOTE: If you want to increase or decrease time while timer is counting down, press up or down arrows. Time will increase or decrease in 5-second intervals. 6. If the blender is not used for five seconds, the timer function will turn off and return to manual mode. To reactivate timer, press up or down arrows. When using the electronic timer again, the initial time will be the last time set. Note: If unit has been turned off or unplugged, the timer will default back to 10 seconds. 7. For continuous operation, press either LO or HI button. When finished blending, press STOP . For momentary operation, press the PULSE button. Motor will run on HI speed until the button is released. NOTE: Your MX Electronic Blender uses a Slow Start™ feature. When pressing HI , the unit will start in the LO speed for 2 seconds and then switch to HI speed. This allows for a more even blending of ingredients in container. 4